| Available up to 81 inches wide, these heat-activated Dry Film Adhesives are made up of 100% solids. There is no off-gassing or moisture added to the substrates being adhered. | |||||
| Multi-layer films allow bonding of very dissimilar surfaces - in ONE step! | |||||
|
Our versatile line of products can bond almost any surface. Heat
activated Dribond® is
a
dry, clear film adhesive that is excellent for adhering:
Heat-activated Dry Film Adhesive Comparison Sheets:Pre-coated backings for wood and paper |
| Pressure Sensitive Adhesive Films |
| (No Heat Needed)
|
| Clear Coat™ Overlay Film |
Clear Coat™ Overlay Dry Film and Sealer
| Available in rolls or sheets | Crystal clear or colored |
| Thickness .002" - .10" | High gloss & Low gloss finishes available |
| Application Temperature is 210°F+ | Extremely long shelf life (no limit found) |
| Fuses to almost any substrate | Not effected by H2O |
| Polyester chemistry | Very good vapor barrier |
| No VOC's | Adds stability and strength |
| Fast - Safe - Easy | FDA safe |
| This film can also be used for clear FDA compliant overlay, giving high or low gloss finish (depending on release sheet used). Temperature fur fusing / bonding overlay to surfaces like smooth wood is approximately 190° F. In certain cases you may wish to heat to 210°F, but generally a lower temperature is better. Estimated time is 2 - 3 minutes at a pressure of about 100 psi (this can vary). Best to hot stack till cool unless your press has a cooling cycle. See Technical Data Sheet | |
| • Wood Veneers • Oil Spill Protection • Fire Retardants • Dry Film Adhesives • Tree Farm • |


